#1

Hi people!

When trying to clean 0.4mm nozzle I accidentally dropped it and the neck broke off of it ?

Is there any hope for me to fix it? If not, does anyone have an experience of using a 3rd party nozzle on Cetus? Which nozzle will suit? I’d buy the original one, but the shipping to Germany is 16$ (!) and I cannot find it locally.

#2

The nozzle and throat can be separated, as the throat (silver part) is just screwed into the nozzle (bronze part). Use another throat from you other nozzles.

Cetus3D-nozzle-throat
Cetus3D-nozzle-throat 499×960 81.5 KB

Cetus3D-nozzle-assembly

#3

If you use a throat from another nozzle just be careful not to over tighten, brass can fracture soooo easily. I was cleaning a nozzle the other day and might have installed a tad too much PTFE tape to the brass threads, thought there was a bit more to go and over-tightened…snap!